USE 2 Strands of 10/2. Tension 7

'E' wrap cast on 60 stitches (30-30). ( Figure 8 the end thread around the left 6 or 7 needles and save yourself the trouble of finishing off this end. [Over one needle, under the next etc]. Hang a cast on comb and two small claw weights.

Select the following pattern according to your machine. On the 930, 940, 950 and 965 electronic machines use #256 set at double high (also know as double length). For the 970 use pattern #45 set at double high (aka double length). For the punch card machine or the 910 use the card or mylar sheet that looks as follows:
x O x O x O x O
O x O x O x O x

Set the row counter to 000.
On electronic machines, move the carriage out side the right turn mark.
On punchcard machines knit 1 row and move your carriage outside the left turn mark.
Set your machine carriage to (Brother/Knit King) KCII or (Silver/Studio) to fairisle.

On electronic machines press start.

All machines: Put your weaving brushes are against gate pegs. (B/KK)W-T position. Move the carriage toward your needles until you reach the material on the bed. Pull the yarn down behind the tension rod to tighten the tension on it. (B/KK) Knit 1 row. Your needles should be selected into a 1 X 1 pattern. Push in both tuck buttons. (S/S) Set carriage to tuck now.

On the punch card machine set the double high feature now.
All machines: Knit to row count 30.

RC 030 (B/KK) Release your tuck buttons (push plain) but leave your machine set at KCII so that it is still reading the pattern and selecting needles. (S/S) Set carriage to stockinet.  Knit 4 rows.

RC 034 Set carriage to tuck. Knit 166 rows (to row count 200).

RC 200 (B/KK) push plain but leave your machine set at KCII. (S/S) Set carriage to stockinet. Knit 4 rows.

RC 204 Set carriage to tuck. Knit 29 rows.

RC 233 Set carriage knob to N-L to turn off patterning and release tuck buttons. Knit 1 row.

RC 234 Bind off. Break yarn and hide end.